Honeywell Voyager MS-9520 USB Barcode Scanner Configuration Guide (Discontinued Model)

For USB port connections:

Plug the end of the barcode scanner cable into an available USB port on your computer.

The barcode scanner should beep to let you know that it is now active. No software driver

is required for your barcode scanner.

Prior to using your bar code scanner, you must configure it for use within your software. To do so,

you must print this page and scan the items below in order. Please note: You MUST print this

sheet, as you will be unable to scan the code on the screen and normally requires a laser printer to print codes clear enough to scan.

Scan this barcode to enter configuration mode. The barcode scanner should beep three times to

let you know it has entered the configuration mode.

Scan this barcode to disable the carriage return suffix:

Scan this barcode to disable the line feed suffix:

Scan this barcode to enable the tab suffix:

To exit the configuration mode, scan this barcode. The barcode scanner should beep three times

to let you know it has exited the configuration mode. This barcode is the same as the very first

barcode in this document.

Your barcode scanner should now be configured to properly work within your software.

If you have any questions or concerns about the installation and configuration of your barcode

scanner, or have any difficulties with any of these instructions, please don’t hesitate to call our

technical support department at 888.486.4343. This concludes the Barcode Scanner

Installation Guide.

SCANNING THE BARCODE BELOW WILL RESET YOUR BARCODE SCANNER TO FACTORY DEFAULT. THIS IS NOT TO BE DONE NOW.

If necessary, to restore the barcode scanner to its factory-default settings, scan the following

barcode. Important! Scanning this barcode will eliminate any programming changes you already

made, and you will need to reprogram your barcode scanner. It will stop working properly with Kennel Connection if you proceed.

Helpful Hints:

• In KC, make sure to go into File, System options, Local tab and enable your barcode scanner and options in the lower right-hand corner.

• If using this barcode scanner for scanning pet key tags into daycare and you want it fully automated, be sure to go into File, System Options, Daycare and place a check mark next to “Auto-create booking and Check-in.”

• If your barcode scanner is NOT scanning anything into Kennel Connection at all, open Notepad on your computer and make sure the cursor is flashing in there. Scan a barcode. If the barcode shows up in notepad, your device may not be configured to properly work with Kennel Connection. Please try the “Add tab suffix” scan again. IF nothing scans into notepad, there is a hardware issue within that device. Please try a new USB port or a different computer. If it still fails, you’ll need to contact the vendor.